Ultrasonic vibrating screen is a new sieving equipment compared with rotary vibrating screen, now PK Machinery will introduce the notes before using in details.
1.The input voltage of ultrasonic vibrating screen power supply is AC 220 V, ultrasonic power output is led by case back panel connection box, the red one is "+".When wiring, please pay attention to the voltage polarity, wrong wiring is not allowed.
2.In the condition of meeting the production requirements, lower power grade is better. Maximum current shouldn’t exceed 0.4.
3.When net rack is without load (the net rack is no tension), please do not start up the ultrasonic generator, otherwise it will cause overflow of power and damage of net rack and the oscillator.
4.Screen mesh must be tight, otherwise it will affect the ultrasonic output and the effect of vibration.
5.Oscillator aviation plug docking screws must be tightened and wrapped with insulating tape well, thus it will prevent dust .During operation, please pay attention to protect the connector.
6.Check whether the screw nut of oscillator and cable plug nut is tightened well or not before using, as well as the screw nut of oscillator and the net rack. In process of operation, pay attention to the protection of case and oscillator cables, cables and oscillator socket should be anti-moisture ,no water is allowed to enter in the connection plug and socket.
7.If the material is conductive, please extend the ultrasonic wire, stay the ultrasonic resonance power away from the screening site in order to prevent the material into the power case causing short-circuit.
8. When replace the screen mesh, scraping the residual gum of inner ring (resonance loop) with a sharp wallpaper knife, please do not grind by grinder wheel in order to prevent damage of resonance loop.
9.Each unit of ultrasonic generator includes a resonant power supply, an oscillator and a net rack. Please recognize each part clearly and don't mix with other ultrasonic generator.
.jpg)
没有评论:
发表评论